Installation Quick-mounted surface installation with easy snap-on bracket that also serves as marking template.
Connection 240v, 60 cycles with armoured cable complete with junction box cover and wire connector supplied with heater. Installation requires a wall box (not included).
Installation height 10 in.
Front: 20 in Sides: 4 in Above: 12 in.
Note 3-conductor cable or 2-conductor cable with a third wire should be used if unit is to be linked with the Convectair Programmer module (7392 FP).
Total capacity (2000 W)
Fan-forced heat (1000 W) Low-thermal-mass heating element combined with low-pressure tangential blower.
Quick heat option (1000 W) Low-thermal-mass heating element combined with low-pressure tangential blower.
Thermal protection Resetable overheat protection. Reset by turning heater off.
Electronic thermostat Built-in electronic proportional-action thermostat for the basic heating.
Timer 0-30 minute resetable mechanical timer for quick heating.
Programmer Programmer-compatible, pilot wire only.
Location Located on top of the unit with protective cover.
Switch On/Off switch, also serves as reset for overheat protection.
Dial 1 Thermostat control.
Dial 2 Timer dial.
Indicator light 1 Heating indicator light.
Indicator light 2 Overheat of saturated filter warning indicator light.
Steel construction with polyester/epoxy anti-rust powder coating.
Cabinet Splash-proof construction with rounded edges and built-in side wire covers.
Louvres Bottom grille directs the hot air downwards, towards the center of the room to ensure even temperature.
Filter Easy-to-clean, removable rear-mounted lint filter for easier maintenance.
Color BB = White
PRICE AND DIMENSIONS *
||41 cm / 16 "
||14 cm / 5 1/2 "
||1000 / 2000
||3412 / 6824
||750 / 1500
||2559 / 5118
Prices are subject to change.