Apero

Installation Quick-mounted surface installation with easy snap-on bracket that also serves as marking template.

Connection 240V, 60 cycles with flexible cord connection, including junction box cover. Installation requires 2" X 3" wall box (not included).

Installation height 4 in (10 cm).

Clearances :
Front: 20 in (50 cm) Sides: 6 in (15 cm) Above: 4 in (10 cm).

Total capacity (500 to 2000 W)
Convection X-shaped monoblock element made of surface-treated extruded aluminium.

Thermal protection, manual reset overheat protection.

Electronic thermostat Built-in electronic proportional-action thermostat ultraprecise to 1/5ºF (1/10ºC)

Programmer Programmer-compatible, pilot wire only.

Location Located on top right hand side of the unit.

"+ and - " Keys Set the temperature and lock the controls.
Key 15-Operating mode selection key:

• Comfort;
• Economy (setback of 7ºF / 4ºC below the Comfort settings);
• Frost protection (45ºF (7ºC) );
• Heat Off;
• Program (automatic setback when connected to the Convectair Programmer – see technical specifications for catalogue number 7392).

Switch On/Off switch (side of unit). Indicator light Heating indicator light. Indicator light Programmer indicator light.

Steel construction with polyester/epoxy anti-rust powder coating.

Cabinet Bottom-mounted protective pan with rounded edges.

Louvres Front-louvered air outlet that hides the unit interior and directs heat towards the centre of the room.

Color : BB = White

For even heat distribution
Natural convection operates on a key principle of physics: hot air rises and cold air falls. When cold air at floor level comes into contact with the X-shaped monoblock heating element, it becomes warm. This element offers exceptional heat conductivity. Each Convectair using natural convection heating therefore transfers as much heat possible to the greatest volume of air.

Thanks to a chimney effect, this warm air rises and is projected through the slanted grille slats toward the centre of the room. Air from the entire room follows in a completely silent, gentle flow. The result is a stable, even temperature. Equipped with precise electronic thermostats, natural convection heaters are the solution of choice for rooms where constant, even comfort is required.

Convectair natural convection heaters do not dry out the air in a room. Since they operate without a fan and the element never heats to red-hot, any particles that are naturally suspended in the air do not burn.
The result: the air stays healthy and the humidity rate remains balanced.  

A Convectair maintains the selected temperature without allowing major fluctuations. Thanks to the electronic thermostat, sensitive to within 1/10 °C (1/5 °F), the room’s occupants can go about their business for as long as they like, in a steadily warm environment without fiddling with the thermostat, oblivious to changes in the outside temperature.

• 2 years against all defects
• 5 years on heating elements

Once the guarantee expires, the Convectair technical team is a reliable source of advice and service. Many years after purchase, most Convectair unit can be repaired and refurbished.

Consult here a list of our authorized Service Centers

For a reliable and guaranteed installation, we recommend that all units be installed by a licensed electrical contractor.